6/11/2023 0 Comments Install tftNote that the 2nd command may take a few minutes to complete but once done you should get "Success" for all components Execute the below two commands to run TouchUI's helper script.Once installed, ignore prompt to restart in the WebUI and instead execute "sudo reboot now" via SSH. ![]() Launch browser, browse to OctoPrint's WebUIm then install the TouchUI Plugin.rotate.sh" again with a different rotation value instead of 180 Very orientation is correct (although should only see text).Sudo dpkg -i -B xinput-calibrator_0.7.5-1_b Execute below commands to configure & rotate display:.Execute the below two commands again which should now succeed and auto reboot again.Once back up, log back in via SSH again then execute "sudo apt -fix-broken install" to resolve the errors encountered prior to auto reboot.Note that the final command auto restarts your RasPi without prompting and you may notice some errors prior to this. Execute the below commands to install the driver.Execute "sudo apt-get install xserver-xorg-video-fbturbo" - depending on your OS image, this will probably fail which is normal.Execute "sudo apt-get update & apt-get upgrade" to upgrade all packages.Install Octoprint and set up as desired - You may physically install the LCD now but do not yet install the TouchUI plugin.Screen: kuman for Raspberry Pi 3B+ TFT LCD Display, 3.5 Inch 480x320 TFT Touch Screen Monitor for Raspberry Pi Model B A+ SPI Interface with Touch Pen SC06 - also referred to as "3.5” RPi Display(MPI3501)" it seems.OS: Used OctoPrint 0.17.0 image which runs Raspbian GNU/Linux 10 (Buster).When rebuilding my OctoPrint server (setup from scratch) recently, I tried again and finally got it to work.īelow are my system specs at the moment followed by how to get it to work if having issues: ![]() None of the steps I had seen from others worked nor did the troubleshooting steps on TouchUI's page. When doing so, the display didn't work, touch was messed up, or there was always some issue. I've spent hours trying to get TouchUI working correctly.
0 Comments
Leave a Reply. |